JVC SP-UXQ1S ユーザーズマニュアル
Introduction
6
English
Prep
aration
Connections
1
Set up the AM loop antenna
(supplied).
2
Connect the antenna cord.
3
Turn the AM loop antenna to find
the best position for radio
reception.
Place the AM loop antenna as far
from the main unit as possible.
• Do not place the AM loop antenna on a
metallic table or close to a TV, computer, or
other electric appliance. Doing so may affect
radio reception.
other electric appliance. Doing so may affect
radio reception.
■When radio reception with the supplied AM
loop antenna is poor
Connecting the Antennas
Connecting the AM antenna
Insert the tab into
the slot.
the slot.
Main unit (rear view)
Main unit (side view)
Connecting the antenna
cord
cord
Connect the ends of
the antenna cord as
shown above.
When insulation
covers the tips of
the antenna cord,
twist and pull off
the insulation.
covers the tips of
the antenna cord,
twist and pull off
the insulation.
Electric wire: 3 - 5 m (commercially available)
Twist together electric
wire and the AM loop
antenna cord.
wire and the AM loop
antenna cord.
Stretch out the electric
wire horizontally,
preferably in a high place
such as above a window
or outdoors.
Connect the AM loop
antenna cord to the main
unit together with the
electric wire.
Main unit (rear view)
Connect all necessary parts before connecting the power plug.
When positioning the antennas, find the best position for reception while listening to an actual radio program
(refer to "Listening to Radio Broadcasts" (
(refer to "Listening to Radio Broadcasts" (
page 14).
UX-Q1[UB].book 6 ページ ２００４年７月２１日 水曜日 午後１時４４分