JVC HX-GX7 ユーザーズマニュアル
5
To assemble and connect the AM loop antenna
To assemble the AM loop antenna
To connect the AM loop antenna cords
• If the AM loop antenna wire or speaker cords are covered with
vinyl, remove the vinyl to expose the tip of the antenna by
twisting the vinyl.
twisting the vinyl.
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. Also, keep the
antennas away from metallic parts of the System, connecting
cords, and the AC power cord. This could cause poor
condition.
antennas away from metallic parts of the System, connecting
cords, and the AC power cord. This could cause poor
condition.
For better FM/AM reception
To connect the speaker cords
To Connect Other Equipment
By using an stereo mini plug cord (not supplied), you can
connect equipment with analog audio output jacks such as an
MD player, a TV, etc.
connect equipment with analog audio output jacks such as an
MD player, a TV, etc.
If the audio output on the other equipment is not stereo
mini plug type,
mini plug type,
use a plug adapter to convert the stereo mini
plug to the corresponding plug of the audio output.
1 Hold
2 Insert
3 Release
ANTENNA
AM EXT
AM
LOOP
FM 75
COAXIAL
Outdoor FM antenna
(not supplied)
Disconnect the supplied FM antenna, and
connect to an outdoor FM antenna using a
75
connect to an outdoor FM antenna using a
75
Ω wire with coaxial type connector.
Vinyl-covered wire (not supplied)
When reception is poor, connect a
single vinyl-covered wire to the AM
EXT terminal and extend it
When reception is poor, connect a
single vinyl-covered wire to the AM
EXT terminal and extend it
AM loop antenna
Keep it connected.
Keep it connected.
• When connecting the speaker cords, match the polarity of
the speaker terminals: (+) to (+) and (–) to (–).
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom of
the speakers.
the speakers.
IMPORTANT
• Always set volume to MIN when connecting or
disconnecting the other equipment.
DO NOT plug in any equipment until all
connections are complete.
connections are complete.
Speaker
cords
(black/blue)
Speaker cords
(black/red)
From right speaker
From left speaker
1 Hold
2 Insert
3 Release
Speaker
cords
(black/blue)
AUX
(front panel)
Audio equipment
output
output
Stereo mini plug cord (not supplied)
HX-GX7.book Page 5 Friday, January 16, 2004 5:25 PM