JVC FS-V100 ユーザーズマニュアル
21
•
If you are having a problem with your System, check this list for a possible solution before calling for service.
•
If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as
your dealer, for service.
your dealer, for service.
Troubleshooting
Possible Cause
•
Connections are incorrect, or loose.
•
Headphones are connected.
•
Antennas are disconnected.
•
The AM Loop Antenna is too close to
the System.
the System.
•
The FM Wire Antenna is not properly
extended and positioned.
extended and positioned.
The CD is upside down.
The CD is dirty or scratched.
The AC power cord is not plugged in.
During tape playing, the power cord was
unplugged.
unplugged.
Cassette record protect tabs are removed.
The built-in microprocessor has
malfunctioned due to external electrical
interference.
malfunctioned due to external electrical
interference.
•
The path between the Remote Control
and the sensor on the Unit is blocked.
and the sensor on the Unit is blocked.
•
The batteries have lost their charge.
Symptom
No sound is heard.
Poor radio reception
The CD does not play.
The CD skips.
The CD cover does not open or close.
The cassette holder cannot be opened.
Unable to record.
Operations are disabled.
Unable to operate the Remote Control.
Action
•
Check all connections and make
corrections. (See pages 2 – 5.)
corrections. (See pages 2 – 5.)
•
Disconnect the headphones.
•
Reconnect the antenna securely.
•
Change the position and direction of the
AM Loop Antenna.
AM Loop Antenna.
•
Extend FM Wire Antenna to the best
reception position.
reception position.
Put the CD in with the label side up.
Clean or replace the CD.
Plug the AC power cord.
Plug in the power cord, press the POWER
button, and then press the TAPE
button, and then press the TAPE
0 button.
Cover the holes on the back edge of the
cassette with adhesive tape.
cassette with adhesive tape.
Unplug the System then plug it back in.
•
Remove the obstruction.
•
Replace the batteries.
Specifications
Speaker Specifications
(each unit)
Speakers
Speakers
8 cm cone
×
1
Impedance
4
Ω
Dimensions
140 mm
×
230 mm
×
211 mm (W/H/D)
(5
9
/
16
in.
×
9
1
/
16
in.
×
8
5
/
16
in.)
Mass
Approx. 1.8 kg (4.0 lbs)
General
Dimensions
438 mm
×
234 mm
×
279 mm (W/H/D)
(17
1
/
4
in.
×
9
7
/
32
in.
×
10
31
/
32
in.)
Mass
Approx. 6.8 kg (15.0 lbs)
Power Specifications
Power Requirements
AC 120 V
, 60 Hz
Power Consumption
50 W (power on mode)
3.7 W (in Standby mode)
3.7 W (in Standby mode)
Accessories
See page 2.
Design and specifications are subject to change without notice.
FS-V100 (CA-FSV100 and SP-UXV100)
Amplifier
Output Power
25 W per channel, min. RMS, at 4
Ω
from 80 Hz to 15 kHz,
with no more than 10% total harmonic distortion.
Input Sensitivity/Impedance (1 kHz)
LINE IN (AUX)
400 mV/48 k
Ω
Speaker terminals
4
Ω
- 16
Ω
Phones
16
Ω
- 1 k
Ω
0 mW - 15 mW per channel output
into 32
into 32
Ω
Cassette Deck
Frequency Response
Type I (Normal)
50 Hz - 14 kHz
Type II (CrO
2
)
50 Hz - 15 kHz
Wow and Flutter
0.15% (WRMS)
CD Player
Signal-To-Noise Ratio
90 dB
Wow And Flutter
Immeasurable
Tuner
FM Tuner
Tuning Range
87.5 MHz - 108.0 MHz
AM Tuner
Tuning Range
530 kHz - 1 710 kHz
EN10-22.FS-V100[J]f
12/12/00, 4:32 PM
21