JVC M45 ユーザーズマニュアル

This section mainly explains operations commonly used when you 
enjoy this system.
• Turn on your TV and select the correct input mode on the TV.

IMPORTANT
Before using the remote control for the following 
operation, 
• Set the remote control mode selector to AUDIO.

7

Press F AUDIO.

Press F STANDBY/ON.

The STANDBY lamp goes off.

When DVD is selected as the source (

A pg. 18), the opening 

screen* appears on the TV screen.

* Opening screen
The following messages may 
appear in the message area 
depending on the status of this 
system.
• “OPEN”/“CLOSE”:

Appears when opening or 
closing the selected disc tray.

• “NOW READING”:

Appears when the system is 
reading the disc information.

• “REGION CODE ERROR!”:

Appears when the Region Code of the DVD does not match the 
code the center unit supports. The DVD cannot be played back.

• “NO  DISC”:

Appears when no disc is loaded to the selected disc tray.

7

Press F AUDIO again.

Press F STANDBY/ON again.

The STANDBY lamp lights.

• The power supply to the subwoofer is linked to the center unit. The 

POWER ON lamp on the subwoofer lights green when the power is 
turned on.

• A small amount of the power is consumed even when the power is 

turned off (center unit only). This is called standby mode and the 
STANDBY lamp lights in this mode. Unplug the power cord from the 
AC outlet to turn the power off completely.

• You can also turn on the system by pressing the following buttons;

•

One of 0 buttons on the center unit

•

One of the source selecting buttons on the remote control

•

One of the DISC (1-5) buttons or 3 on the center unit.
You can use the same buttons on the remote control except after 
pressing FM/AM.

Source 
selecting 
buttons

Remote control

mode selector

Illumination lamp

Message area

TH-M45[B].book  Page 17  Wednesday, April 2, 2003  12:52 PM