JVC M45 ユーザーズマニュアル

You can browse through all the stations or use the preset function to 
go immediately to a particular station.

IMPORTANT
Before using the remote control for the following 
operation; 
1 Set the remote control mode selector to 

AUDIO.

2 Press FM/AM.

Each time you press the button, the band alternates between 
FM and AM (MW).
The selected band appears on the display window, then the last 
received station appears.

Example: When AM is selected

Press TUNING ª or TUNING · 
repeatedly until you find the frequency 
you want.

When you hold down the button until the system starts 
searching for stations and then release it, the system stops 
searching automatically when a station of sufficient signal 
strength is tuned in to.

• TUNING ª: Increases frequency.
• TUNING ·: Decreases frequency.

• When a station of sufficient signal strength is tuned in, the TUNED 

indicator lights on the display window.

• When an FM stereo program is received, the ST indicator lights on the 

display window.

Once a station is assigned to a channel number, the station can be 
quickly tuned in. You can preset 30 FM and 15 AM (MW) stations.

7

NOTE
Before you start operation;

• There is a time limit when doing the following steps. If the setting is 

cancelled before you finish, start from step 2 again.

• For the detailed procedure, see “Manual tuning”.
• If you want to store the FM reception mode for an FM 

station, select the reception mode you want. See “Selecting 
the FM reception mode” (

Number buttons

Remote control

mode selector

After a few seconds

TH-M45[B].book  Page 25  Wednesday, April 2, 2003  12:52 PM