JVC M45 ユーザーズマニュアル

Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC service center.

Power does not come 
on.

The power cord is not connected to the center unit or an 
AC outlet.

Connect the power cord correctly. (

Power is not supplied to 
the powered subwoofer.

The power cord of the subwoofer is not connected to an 
AC outlet.

Turn off the system, plug the power cord firmly into an 
AC outlet, and turn on the system again. (

A pg. 13, 17)

The system cord is not connected.

Connect the system cord. (

The system does not 
work correctly.

Lightning or electronic noise interferes with operation 
of the microcomputer.

Switch the power off, then disconnect/reconnect the 
power plug.

Immediately after beginning to heat the room, the 
system was moved to a cold location causing 
condensation to form inside.

Switch the power off and leave the system a few hours 
before switching the power on again.

The remote control does 
not work.

It is too far from the center unit, or is not facing the 
center unit.

Move closer to the center unit. (Operate the remote 
control within 7 m of the center unit.) (

There is something obstructing the remote sensor.

Remove any obstacles. (

The remote control is not aimed at the remote sensor on 
the center unit or components.

Aim the remote control at the remote sensor on the 
equipment you want to operate. (

The remote control mode selector is set at an incorrect 
position.

Set the selector to the correct position. (

The batteries are exhausted.

Replace the batteries. (

The batteries have been inserted the wrong way round 
(+/–).

Insert the batteries correctly. (

The remote control is not set to operate the DVD player 
or tuner (FM/AM – MW).

For the DVD player, press DVD before you perform the 
operations. (

For the tuner, press FM/AM before you perform the 
operations. (

Sunlight is falling directly on the remote sensor.

Hide the remote sensor from direct sunlight.

The remote control signals are not set correctly.

Enter the correct manufacturer’s code. (

To get the best performance out of this system, keep your discs and 
mechanism clean.

7

In general, you will have the best performance by keeping your 
discs and the mechanism clean.
• Store discs in their cases and keep them in cabinets or on shelves.

7

• Remove the disc from its case by holding it at 

the edge while pressing the center hole lightly.

• Do not touch the shiny surface of the disc or 

bend the disc.

• Put the disc back in its case after use to 

prevent warping.

• Be careful not to scratch the surface of the 

disc when placing it back in its case. 

• Avoid exposure to direct sunlight, temperature 

extremes and moisture.

To clean the disc 
Wipe the disc with a soft cloth in a straight line 
from center to edge.

7

• Stains on the system should be wiped off with a soft cloth. If the 

system is heavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe clean with a 
dry cloth.

• Since the system may deteriorate in quality, become damaged or 

get its paint peeled off, be careful about the following.

•

DO NOT wipe it with a hard cloth.

•

DO NOT wipe it strong.

•

DO NOT wipe it with thinner or benzine.

•

DO NOT apply any volatile substance such as insecticides to it.

•

DO NOT allow any rubber or plastic to remain in contact with 
it for a long time.

TH-M45[B].book  Page 57  Wednesday, April 2, 2003  12:52 PM