JVC CA-MXDK5 ユーザーズマニュアル

@

 

• MX-DK3 has only one subwoofer.
• When connecting the speaker cords, match the polarity of 

the speaker terminals: (+) to (+) and (–) to (–).

• Use only speakers with the same speaker impedance as 

indicated by the speaker terminals on the rear of the unit.

¤

 

• The surround speakers connected can reproduce the bass 

sounds recorded in front left and right channels, but cannot 
reproduce the surround signals recorded in DVD multi-
channel discs.

#

 

• When connecting the speaker cords, match the polarity of 

the speaker terminals: (+) to (+) and (–) to (–).

• Use only speakers with the same speaker impedance as 

indicated by the speaker terminals on the rear of the unit.

• The speakers are magnetically shielded to avoid color 

distortions on TVs. However, if not installed properly, it 
may cause color distortions. So, pay attention to the 
following when installing the speakers.
– When placing the speakers near a TV set, turn off the TV’s 

main power switch or unplug it before installing the 
speakers.
Then wait at least 30 minutes before turning on the TV’s 
main power switch again.

Some TVs may still be affected even though you have 
followed the above. If this happens, move the speakers away 
from the TV.

Stereo mini plug

(not supplied)

From left 
subwoofer

From right

subwoofer

From the subwoofer

 

• DO NOT connect more than one speaker to 

each terminal.

• DO NOT push or pull the speakers as this 

will damage the foot spacers at the bottom 
of the speakers.

From right surround 
speaker (not supplied)

From left surround 
speaker (not supplied)

From right

main speaker

From left 
main speaker

MX_DK5_3_1.book Page 5 Tuesday, February 7, 2006 11:49 AM