JVC GVT0267-009A ユーザーズマニュアル
55
O
p
e
ra
ting othe
r e
quipme
n
t
Before the DBS operation, select the remote
control mode for the DBS.
control mode for the DBS.
■ IMPORTANT
• Slide the remote control mode
• Slide the remote control mode
selector to the lowest position.
1
Press [DBS].
2
Operate the remote control by
pointing it at the DBS.
pointing it at the DBS.
NOTE
• When the remote control mode selector is slid to
• When the remote control mode selector is slid to
the lowest position and [DBS] is pressed, some
buttons may not work.
buttons may not work.
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
■ IMPORTANT
• Slide the remote control mode
• Slide the remote control mode
selector to the lowest position.
1
Press [VCR].
2
Hold down [DBS/VCR
F
].
• Hold down [DBS/VCR
F
] until you finish
step 5.
3
Press [ENTER].
4
Press number buttons to enter the
manufacturer code.
manufacturer code.
Examples:
For a Hitachi VCR: Press [0], then [4].
For a Mitsubishi VCR: Press [1], then [3].
When the manufacturer of your VCR has 2 or
more codes, enter the manufacturer codes in
turn and find the one that operates the VCR
and the remote control properly.
For a Hitachi VCR: Press [0], then [4].
For a Mitsubishi VCR: Press [1], then [3].
When the manufacturer of your VCR has 2 or
more codes, enter the manufacturer codes in
turn and find the one that operates the VCR
and the remote control properly.
The initial code setting is “01 (JVC)”.
5
Release [DBS/VCR
F
].
NOTE
• It is recommended that you slide the remote
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
when the remote control mode selector is at
[AUDIO].
• Manufacturer codes are subject to change
without notice. You may not be able to operate
the VCR produced by the manufacturer.
the VCR produced by the manufacturer.
• After replacing the batteries of the remote
control, set the manufacturer code again.
Remote control button Usage
[DBS/VCR
[DBS/VCR
F
]
Turns on/off the DBS.
[CH +/
–
]
Changes channels.
Number buttons (1-9, 0,
10)
Selects the channels.
Operating a VCR using the
remote control
remote control
Using the remote control for the
DBS operation
DBS operation
Setting the manufacturer code
Manufacturer
Code
JVC
01, 02, 03
Emerson
11, 26
Fisher
29
Funai
10, 14, 15, 16
Gold Star
12
Hitachi
04
Mitsubishi
13
NEC
25
Panasonic
07, 17
Philips
09
RCA
05, 06
Samsung
24
Sanyo
21, 22, 23
Sharp
27, 28
Shintom
30
Sony
18, 19, 20
Zenith
08
Operating other equipment (continued
)
NX-F30[U].book Page 55 Tuesday, April 21, 2009 6:23 PM