JVC CA-UXG45 ユーザーズマニュアル

To connect the AM loop antenna
Make sure to connect the wire correctly: The white end to 
AM EXT, the black end to GND.

• If the AM loop antenna wire or speaker cords are covered 

with vinyl, remove the vinyl to expose the tip of the 
antenna by twisting the vinyl.

• Make sure the antenna conductors do not touch any other 

terminals, connecting cords and power cord. Also, keep the 
antennas away from metallic parts of the System, 
connecting cords, and the AC power cord. This could cause 
poor reception.

Make sure the both speakers are connected correctly and 
firmly.

When connecting the speaker cords, match the polarity of 
the speaker terminals: The cord with black stripe to (–), the 
cord without stripe to (+).

Use a screwdriver to slide the voltage selector so that the 
voltage marker is pointing at the same voltage as where you 
are plugging in the unit. (See also the back cover page.)

1 Hold

2 Insert

3 Release

• DO NOT connect more than one speaker to 

each terminal.

• DO NOT allow the conductor of the speaker 

cords to be in touch with the metallic parts of 
the System. 

DO NOT plug in before setting the voltage 
selector on the rear of the unit and all 
connection procedures are complete.

1 Hold

2 Insert

3 Release

220V-240V

AC  VOLTAGE

SELECTOR

110V-127V

Voltage marker

UX-G45[UW].BOOK  Page 7  Tuesday, May 30, 2006  2:07 AM