JVC CA-UXG200 ユーザーズマニュアル
19
Daily Operations—Sound & Other Adjustments
(see pages 11 and 12)
Adjusting the Volume:
• Be sure to turn down the volume before connecting or putting
Adjusting the Volume:
• Be sure to turn down the volume before connecting or putting
the headphones.
Adjusting the Sound:
• This function also affects the sound through the headphones.
Setting the Clock:
• “AM 12:00” flashes on the display until you set the clock.
• The clock may gain or lose 1 to 2 minutes per month. If this
• This function also affects the sound through the headphones.
Setting the Clock:
• “AM 12:00” flashes on the display until you set the clock.
• The clock may gain or lose 1 to 2 minutes per month. If this
happens, set the clock again.
Advanced Disc/USB Mass Storage Class Device
Operations
Operations
(see pages 13 to 15)
Programming the Playing Order—Program Play:
• If you try to program a 33rd track, “PROGFUL” appears on
• If you try to program a 33rd track, “PROGFUL” appears on
the display.
• While programming steps...
Your entry will be ignored if you have tried to program an item
number that does not exist on the disc (for example, selecting
track 14 on a disc that only has 12 tracks).
number that does not exist on the disc (for example, selecting
track 14 on a disc that only has 12 tracks).
Daily Timer Operations
(see pages 16 and 17)
• When you unplug the AC power cord or if a power failure
occurs, the timer will be canceled. You need to set the clock
first, then the timer again.
first, then the timer again.
Troubleshooting
If you are having a problem with your System, check this list
for a possible solution before calling for service.
for a possible solution before calling for service.
General:
Adjustments or settings are suddenly canceled before
you finish.
] There is a time limit. Repeat the procedure again.
Operations are disabled.
] The built-in microprocessor may malfunction due to
you finish.
] There is a time limit. Repeat the procedure again.
Operations are disabled.
] The built-in microprocessor may malfunction due to
external electrical interference. Unplug the AC power cord
and then plug it back in.
and then plug it back in.
Unable to operate the System from the remote control.
] The path between the remote control and the remote sensor
] The path between the remote control and the remote sensor
on the System is blocked.
] Point it at the remote sensor on the front panel.
] Move closer to the System.
] The batteries are exhausted.
No sound is heard from the speakers.
] Speaker connections are incorrect or loose (see page 5).
No sound is heard from the speakers.
] Speaker connections are incorrect or loose (see page 5).
] Headphones are connected (see page 7).
Radio Operations:
Hard to listen to broadcasts because of noise.
] Antenna connections are incorrect or loose.
] Antenna connections are incorrect or loose.
] The AM loop antenna is too close to the System.
] The FM antenna is not properly extended or positioned.
UX-G200[J].BOOK Page 19 Tuesday, December 2, 2008 3:05 PM