JVC RX-6040B ユーザーズマニュアル
11
Basic Operations
The following operations are commonly used when you play any sound sources.
Operations hereafter will be explained using the buttons on the front panel.
You can also use the buttons on the remote control for the same functions if they have the same and similar names/marks.
You can also use the buttons on the remote control for the same functions if they have the same and similar names/marks.
Selecting the Source to Play
When you have connected digital source components using the
digital terminals, first change the input mode for these components
to the digital input mode (see page 13).
digital terminals, first change the input mode for these components
to the digital input mode (see page 13).
Press one of the source selection buttons.
For RX-6040B/RX-6042S
Note:
When you select “DVD MULTI,” you can enjoy analog discrete output
sound (5.1-channel surround reproduction) from the external
component.
• You may need to select analog discrete output mode on the
sound (5.1-channel surround reproduction) from the external
component.
• You may need to select analog discrete output mode on the
external component.
• When using the headphones, you can listen to the front channel
sounds (left and right) only.
• Surround and DSP modes (see pages 25 and 28) cannot be
applied to “DVD MULTI.”
For RX-5040B/RX-5042S/RX-5045B
Note:
When connecting a CD recorder to the TAPE/CDR jacks, change the
source name shown on the display. For details, see page 14.
source name shown on the display. For details, see page 14.
Daily Operational Procedure
1 Turn on the power.
• See “Turning On the Power” below.
2 Select the source.
• See “Selecting the Source to Play” to the right.
3 Adjust the volume.
• See “Adjusting the Volume” on page 12.
4 Select the Surround or DSP modes.
• See “Activating the Surround Modes” (page 27) and
“Activating the DSP Modes” (page 29).
Turning On the Power
Press STANDBY/ON
(or STANDBY/ON
AUDIO on
the remote control).
The STANDBY lamp goes off.
To turn off the power (into standby mode),
press STANDBY/ON
press STANDBY/ON
(or STANDBY/ON
AUDIO on the
remote control) again.
The STANDBY lamp lights up.
The STANDBY lamp lights up.
Note:
A small amount of power is consumed in standby mode. To turn off
the power completely, unplug the AC power cord.
the power completely, unplug the AC power cord.
On the front panel
On the remote
On the front panel
On the remote
VOLUME
Current source name appears.
Current volume level appears.
DVD MULTI
DVD
VCR
CD
FM
AM
TAPE/CDR
TV SOUND
SOURCE NAME
TAPE/CDR
CD
DVD
DVD MULTI
FM/AM
TV SOUND
VCR
DVD
VCR
CD
FM/AM
TAPE/CDR
TV SOUND
SOURCE NAME
TAPE/CDR
CD
DVD
FM/AM
TV SOUND
VCR
Selected source name appears.
VOLUME
11-15_5040&6040[J]f.p65
03.12.20, 14:28
11