JVC DD-1 ユーザーズマニュアル

Press 2 or 3 to select the video 
signal type suitable for the TV. 

• When the TV is connected to the [VIDEO] 

terminal or the [S-VIDEO] terminal, the 
video signal type can be selected as 
instructed below.
- Select “PAL 576I” for a TV only compatible 

with PAL interlaced video signal. 

- Select “PAL 576P” for a TV equipped with 

a component terminal and compatible with 
PAL progressive video signal. 

- Select “NTSC 480I” for a TV only compati-

ble with NTSC interlaced video siginal.

- Select “NTSC 480P” for a TV equipped 

with a component terminal and compatible 
with NTSC progressive video signal.

• When the TV is connected to the [HDMI] ter-

minal, the video signal type can be selected 
as instructed below. (Only for DD-8 and DD-3)
- Select “AUTO” for normal usage (the initial 

setting).* 

- Select “PAL 576P”, “PAL 720P”, 

“NTSC 480P” or “NTSC 720P” as needed.

NOTE
* The “AUTO” setting works only for a TV compat-

ible with PAL video signal. Select “NTSC 480P” 
or “NTSC 720P” for a TV equipped with an HDMI 
terminal and compatible with NTSC video signal. 

• “480”, “576” and “720” refer to the number of the 

scanning lines. Generally, the larger the number, 
the better picture that can be obtained.

• “I” refers to the interlaced format. “P” refers to 

the progressive format. A better picture can be 
obtained in the progressive format than in the 
interlaced format.

• When an HDMI video signal is output, the 

“HDMI” indicator lights up in the display window. 

• When an HD video signal (720p) is output, the 

“HD” indicator lights up.

• When “PAL 576P”, “PAL 720P”, “NTSC 480P” or 

“NTSC 720P” is selected, the “PROGRESSIVE” 
indicator lights up in the display window.

• The selected video signal type is displayed 

in the display window for a short time. 

NOTE
• The picture may be distorted when you press 

[ENTER], but this is not a malfunction of the sys-
tem.

• To check the compatibility of your TV, contact 

your local JVC customer service center.

• All JVC-manufactured progressive TVs and 

high-definition TVs are fully compatible with this 
system.

• Even if the main unit is turned off, the video sig-

nal type setting is stored. 

To view an image on the TV, select the monitor out 
type as well as the video signal type.

Press 5 or / to display “M.OUT”. 

Press 2 or 3 to select “HDMI” or 
“NO HDMI”. 

• When using an HDMI cable to connect a TV 

to the main unit, select “HDMI”.

• When an HDMI cable is not connected, 

select “NO HDMI” (the initial setting).

Selecting the monitor out type

DD-831[A_Ux]-03.fm  Page 14  Friday, October 13, 2006  11:10 AM