JVC DX-T9 ユーザーズマニュアル

@

 

• When connecting the speaker cords, match their polarity 

with that of the speaker terminals: blue/red/green/white/
gray to (+) and black to (–).

• Use only speakers with the same speaker impedance as 

indicated by the speaker terminals on the rear of the System.

• The front and center speakers are magnetically shielded to 

avoid color distortions on TVs. However, if not installed 
properly, it may cause color distortions. So, pay attention to 
the following when installing the speakers.
– When placing the speakers near a TV set, turn off the 

TV’s main power switch or unplug it before installing the 
speakers.
Then wait at least 30 minutes before turning on the TV’s 
main power switch again.

Some TVs may still be affected even though you have 
followed the above instruction. If this happens, move the 
speakers away from the TV.

 

• Dispose of batteries in the proper manner, according to 

federal, state, and local regulations.

• DO NOT connect more than one speaker to 

each terminal.

• DO NOT push or pull the speakers as this 

will damage the foot spacers at the bottom 
of the speakers.

From right front speaker (blue/black)

From left front speaker 
(blue/black)

From left surround 
speaker (white/black)

From right surround 
speaker (white/black)

From center 
speaker 
(green/black)

From left subwoofer 
(red/black)

From right 
subwoofer 
(red/black)

 

To enjoy multi-channel sound, locate the speakers as 
follows. If you cannot locate like this, adjust the speaker 
setting by using the SPK. SETTING menu (see page 38).

 

 point the top of the 

remote control toward the 
remote sensor as directly as 
possible. If you operate it 
from a diagonal position, 
the operating range (approx. 
5 m) may be shorter.

DO NOT recharge, short, disassemble, heat 
the battery or dispose of it in a fire.

Holes

Speaker grille

Projection

R6(SUM-3)/AA(15F)

DX_T9[J].book Page 5 Tuesday, December 13, 2005 1:53 PM