JVC FS-H35 ユーザーズマニュアル
10
Common Operations
Setting the Clock
Before operating the unit any further, first set the unit’s
clock. When you plug in the power cord, the
clock. When you plug in the power cord, the
CLOCK
indicator and “AM 12:00” start flashing on the display.
You can set the clock whether the unit is on or off.
• There is a time limit in doing the following steps. If
You can set the clock whether the unit is on or off.
• There is a time limit in doing the following steps. If
the setting is canceled before you finish, start over
from step
from step
1
.
On the remote control:
1
Press CLOCK/TIMER.
The hour digits start flashing on the
display.
display.
2
Press
UP or
DOWN to
adjust the hour, then press
CLOCK/TIMER.
CLOCK/TIMER.
The minute digits start flashing.
3
Press
UP or
DOWN to adjust the
minute, then press CLOCK/TIMER.
On the unit:
1
Press TIMER/SNOOZE.
The hour digits start flashing on
the display.
the display.
2
Press
¢ or 4 to
adjust the hour, then
press TIMER/SNOOZE.
press TIMER/SNOOZE.
The minute digits start flashing.
CLOCK
/ TIMER
CLOCK
CLOCK
CLOCK
TIMER/SNOOZE
DISPLAY
3
Press
¢ or 4 to adjust the minute,
then press TIMER/SNOOZE.
To check the clock time during play
On the remote control ONLY:
Press DISPLAY (grey-colored).
• Each time you press the button, the
• Each time you press the button, the
source indication and the clock time
alternate on the display.
alternate on the display.
• When you unplug the power cord or if a power failure
occurs
The clock is reset to “AM 12:00” right away. If this
happens, set the clock again.
The clock is reset to “AM 12:00” right away. If this
happens, set the clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
To change the clock
1
Make sure the
(timer) indicator is not lit on
the display.
• If it is lit, press and hold CLOCK/TIMER (or
• If it is lit, press and hold CLOCK/TIMER (or
TIMER/SNOOZE on the unit) until it goes off.
2
Press CLOCK/TIMER (or TIMER/SNOOZE
on the unit) repeatedly until the unit enters the
clock setting mode (the hour digits start flashing
on the display).
First time you press CLOCK/TIMER (or TIMER/
SNOOZE on the unit), the unit enters the timer
setting mode. (See page 20.)
on the unit) repeatedly until the unit enters the
clock setting mode (the hour digits start flashing
on the display).
First time you press CLOCK/TIMER (or TIMER/
SNOOZE on the unit), the unit enters the timer
setting mode. (See page 20.)
3
Repeat steps
2
and
3
of the procedure of
“Setting the Clock.”
4
Press and hold CLOCK/TIMER (or TIMER/
SNOOZE on the unit) again so that the
(timer) indicator goes off.
SNOOZE on the unit) again so that the
(timer) indicator goes off.
UP
DOWN
CLOCK
/ TIMER
TIMER/SNOOZE
Continued
EN01-13_FS-H30[J]f.pm6
03.2.5, 4:32 PM
10