JVC EX-A10 ユーザーズマニュアル

ページ / 176
41
Connect the other audio equipment to this system 
in advance (
A page 12).
1
Slide the remote control 
mode selector to 
RECEIVER.
2
Press AUX to select 
“AUX-DIGITAL” or “AUX”.
• Each time you press AUX, the display on 
the receiver toggles between 
“AUX-DIGITAL” and “AUX”.
• The source changes to the signal from the 
AUX terminals.
• You can also use SOURCE SELECT on the 
receiver to select the signal from the AUX 
terminals as the sound source.
3
Begin playback on the other 
audio equipment.
• For details on beginning playback, refer to 
the manual of the connected equipment.
4
Adjust the volume and the 
sound quality of the system 
(
page 16).
NOTE
• When no equipment is connected to the DIGITAL IN 
AUX terminal or the power of the connected 
equipment is off, after “AUX-DIGITAL” is selected, 
the display changes to “AUX-D UNLOCK”.
Adjust the sound input level of the audio 
equipment
You can adjust the sound input level of audio 
equipment connected to the AUX terminals.
1
Slide the remote control 
mode selector to 
RECEIVER.
2
Press AUX to select “AUX”.
• Each time you press AUX, the display on 
the receiver toggles between 
“AUX-DIGITAL” and “AUX”. 
• The source changes to the signal from the 
AUX terminals.
3
Hold down MEMORY until the 
input level is displayed.
• Each time you hold down the button, the 
input level switches as follows:
LEVEL1 STORED: For normal use.
 (initial 
setting)
LEVEL2 STORED: To correct distorted 
sound caused by an 
extremely high input 
level from other 
equipment.
AUX
MEMORY
3
 (play)
Remote control 
mode selector
Listening to the sound of other audio equipment
Listening to the sound of other audio equipment
EXA10[A_Ux].book  Page 41  Tuesday, August 30, 2005  3:53 PM