Sharp MD-MX10H ユーザーズマニュアル
![Sharp](https://files.manualsbrain.com/attachments/09c3752719497cddb7682a2870f2b01d664ac839/common/fit/150/50/128db0ff9ffd18d046ef9a246eb7bdc77b15206699c58d5f48a715e1dba1/brand_logo.png)
9
SETTING THE CLOCK
●
In this example, the clock is set for the 24-hour (0:00) sys-
tem.
tem.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK button.
3
Within 5 seconds, press the MEMORY/ENTER button.
4
Turn the jog dial to select the time display mode.
"0:00"
→
The 24-hour display will appear.
→
(0:00 - 23:59)
"12:00 AM"
→
The 12-hour display will appear.
→
(AM or PM 12:00 - 11:59)
"0:00 AM"
→
The 12-hour display will appear.
→
(AM or PM 0:00 - 11:59)
●
Note that this can only be set when the unit is first in-
stalled or it has been reset (see page 36).
stalled or it has been reset (see page 36).
5
Press the MEMORY/ENTER button.
6
Adjust the hour by turning the jog dial.
●
When the jog dial is turned one click clockwise, the time
will increase by 1 hour. When it is turned one click anti-
clockwise, the time will decrease by 1 hour.
Keep turning the jog dial to change the time continuously.
will increase by 1 hour. When it is turned one click anti-
clockwise, the time will decrease by 1 hour.
Keep turning the jog dial to change the time continuously.
●
When the 12-hour display is selected, “AM” will change
automatically to “PM”.
automatically to “PM”.
7
Press the MEMORY/ENTER button.
8
Adjust the minutes by turning the jog dial.
●
When the jog dial is turned one click clockwise, the time
will increase by 1 minute. When it is turned one click anti-
clockwise, the time will decrease by 1 minute.
Keep turning the jog dial to change the time continuously.
will increase by 1 minute. When it is turned one click anti-
clockwise, the time will decrease by 1 minute.
Keep turning the jog dial to change the time continuously.
●
The hour setting will not advance even if minutes advance
from "59" to "00".
from "59" to "00".
9
Press the MEMORY/ENTER button.
●
The clock starts operating from "0" second.
(Seconds are not displayed.)
(Seconds are not displayed.)
To see the time display:
Press the CLOCK button.
●
The time display will appear for about 5 seconds even in
the stand-by mode.
the stand-by mode.
Note:
●
The "CLOCK" will appear at the push of the CLOCK button
when the AC power supply is restored after a power failure
occurs or after the AC power lead is disconnected.
If this happens, follow the procedure below to change the
clock time.
when the AC power supply is restored after a power failure
occurs or after the AC power lead is disconnected.
If this happens, follow the procedure below to change the
clock time.
To change the clock time:
1
Press the CLOCK button.
2
Within 5 seconds, press the MEMORY/ENTER button.
3
Perform steps 6 - 9 above.
To change the time display mode:
1
Reset the microcomputer (see page 36).
2
Perform steps 2 - 9 above.
MEMORY/
ENTER
ENTER
Jog dial
ON/STAND-BY
CLOCK