Philips FW-D596 ユーザーズマニュアル

ページ / 48
46
English
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty.  Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you
are unable to remedy a problem by following these hints, consult your dealer or service center.
Problem
Solution
No power.
– Check if the AC power cord is properly
connected.
UNREADBLE DISC” is displayed.
– Check if the disc is inserted upside down.
– Wait until the moisture condensed at the lens
has cleared.
– Replace or clean the disc, see “Maintenance”.
– Use a readable disc or correctly recorded format
MP3-CD.
No picture.
– Select the appropriate video input mode on the
TV set.
– Check if the TV set is switched on.
– Check the video connection.
– Check if the system is securely connected.
Distorted or poor picture.
– Sometimes a slight picture distortion may appear.
This is not a malfunction.
– Clean the disc.
– Connect the system to the S-video input of your
TV set.
The aspect ratio of the screen
– The aspect ratio is fixed on the DVD disc.
cannot be changed even though
– The aspect ratio may not be changed for some
you have set the TV shape.
TV systems.
The DVD player does not
– Insert a readable disc.
start playback.
– Check the disc type, color system and region
code.
– Clean the disc.
– Place the disc with the playback side down.
– Press SYSTEM MENU to turn off the setup
menu.
– Cancel the parental control rating function or
change the rating level.
– Moisture has condensed inside the system.
Remove the disc and leave the system turned on
for about an hour.
The system does not respond
– Disconnect the power plug from the jack, and
when the buttons are pressed.
insert again.
The language for the sound or
– Multi-language sound or subtitle is not recorded
subtitle cannot be changed when
on the DVD.
playing a DVD.
– Changing the language for the sound or subtitle is
prohibited on the DVD.
No image is output when a
– Make sure the component is connected correctly.
function is selected.
– Press the correct function button for the input
source.
Troubleshooting