ONKYO T-433 ユーザーズマニュアル

 

14

 

If you’re using the T-433 together with the A-933 
amplifier from the Onkyo Separate Collection, press the 
remote controller’s [ON] button once to turn on the 
A-933, and press it again to turn on the T-433.

To set the entire system to Standby, press the remote 
controller’s [STANDBY] button.

 

To turn on only the A-933 and T-433, press T-433’s 
[BAND] button or the remote controller’s [FM] or 
[AM] button.

 

The very first time you turn on the T-433, the Accuclock 
function automatically sets the clock by using the CT 
(Clock Time) information present in RDS radio broad-
casts. While the clock is being set, “WAIT” flashes on 
the display, as shown. It may take up to 5 minutes to set 
the clock.

When the clock has been set, the message “CLOCK 
ADJUSTED” scrolls across the display, then the day 
and time are displayed for a while, as shown.

The Accuclock function automatically updates the clock 
daily at 2 A.M., 3 A.M. and 2 P.M.

If the clock is incorrect, see “Setting the Clock Manu-
ally” on page 21.

 

The T-433 turns on, and the 
STANDBY indicator goes off.

To turn off the T-433, press the 
[STANDBY/ON] button. The T-433 
will enter Standby mode.

The T-433 is not completely shutdown 
in Standby mode.

*En_T433_02.fm Page 14 Tuesday, February 15, 2005 3:09 PM