Toshiba RD-XS32SC ユーザーズマニュアル
20
Is your recorder ready?
• Refer to the supplied “INSTALLATION GUIDE”
• Refer to the supplied “INSTALLATION GUIDE”
manual and finish the necessary preparations.
• Turn on the connected equipment such as a TV or
audio system and select the input from the recorder.
Turning the power on
(This owner’s manual instructions are based on
the assumption that all proper connections have
been completed and the TV is turned on.)
(This owner’s manual instructions are based on
the assumption that all proper connections have
been completed and the TV is turned on.)
Press ON/STANDBY on the front panel of the
recorder or on the remote control.
recorder or on the remote control.
When the power turns on, the ON/STANDBY indicator
changes from red (standby mode) to green (operation).
After a few seconds, a start-up screen appears.
The following icon appears at the top right corner of
the screen.
changes from red (standby mode) to green (operation).
After a few seconds, a start-up screen appears.
The following icon appears at the top right corner of
the screen.
When this icon disappears, the recorder is ready to
operate. If the disc drive contains a disc, it takes a
little longer to start up.
operate. If the disc drive contains a disc, it takes a
little longer to start up.
Viewing TV channels through this recorder
After turning the power on, the recorder will output TV
channel signals to the connected TV (also in the stop
mode).
You can select a desired channel by pressing the
CHANNEL or the number buttons.
(These buttons can select channels of a connected
cable box or satellite system, if “IR control” (
After turning the power on, the recorder will output TV
channel signals to the connected TV (also in the stop
mode).
You can select a desired channel by pressing the
CHANNEL or the number buttons.
(These buttons can select channels of a connected
cable box or satellite system, if “IR control” (
page
37, in “INSTALLATION GUIDE”) is set to “On”.)
Loading a disc
Check disc compatibility beforehand (
Check disc compatibility beforehand (
page 6, 7)
and use a proper playable disc.
Caution
• Keep your fingers well clear of the disc tray. Neglecting this
• Keep your fingers well clear of the disc tray. Neglecting this
may cause serious personal injury. Keep a close watch on
children.
children.
• Do not use a cracked, deformed, or repaired disc.
1 Open the disc tray.
Press
on the front panel or the OPEN/CLOSE
button on the remote control.
2 Insert a disc.
Disc without a cartridge
Insert with the playback side down.
There are two kinds of disc size. Place a disc to fit
the guide. If a disc is out of the guide, it may result
in damage to the disc or malfunction.
the guide. If a disc is out of the guide, it may result
in damage to the disc or malfunction.
Place a disc in the
inside hollow.
inside hollow.
Introduction
Before operating this recorder
ON/STANDBY button
CHANNEL buttons
ON/STANDBY button
ON/STANDBY indicator
OPEN/CLOSE button
button
Loading
e.g.