ONKYO 29400086 ユーザーズマニュアル

En-

9

■ Front

STANDBY/ON indicator
Red:

Subwoofer in standby mode

Blue:

Subwoofer on

With the Auto Standby function, the SKW-770 
automatically turns on when an input signal is 
detected in Standby mode. When there’s no input 
signal for a while, the SKW-770 automatically 
enters Standby mode.

■ Rear

a OUTPUT LEVEL control

This control is used to adjust the volume of the 
subwoofer.

b LINE INPUT

This RCA input should be connected to the 
subwoofer pre out on your AV receiver with 
supplied RCA cable.

Note:
The Auto Standby function turns the subwoofer on when 
the input signal exceeds a certain level. If the Auto 
Standby function does not work reliably, try slightly 
increasing or decreasing the subwoofer output level on 
your receiver.

To set the level of the subwoofer, use the OUTPUT 
LEVEL control. Set it so that bass sounds are evenly 
balanced with the treble sounds from the other speakers. 
Because our ears are less sensitive to very low bass 
sounds, there’s a temptation to set the level of the 
subwoofer too high. As a rule of thumb, set the 
subwoofer level to what you think is the optimal level, 
and then back it off slightly.

STANDBY/ON indicator

a

b

To AC outlet

HTP-770_EnFrEs.book  Page 9  Wednesday, July 29, 2009  10:07 AM