Electro-Voice DH2T-8 プリント

U.S.A. and Canada only. For customer orders, contact Customer Service at:

Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:

Other International locations. For customer orders, contact Customer Service at:

For warranty repair or service information, contact the Service Repair department at:

For technical assistance, contact Technical Support at: 866/78AUDIO

Specifications subject to change without notice.

12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043

© Telex Communications, Inc. 2/2002
Part Number 38110-094 Rev. A

 Pure aluminum rectangular voice coil wire is used to obtain
the highest sensitivity. Proprietary bonding and winding
technologies assure unsurpassed reliability and performance
of all DH2T diaphragm assemblies.

Electro-Voice’s commitment to precision compression driver
manufacturing and modern design techniques assure the
DH2T user the highest level of audio and engineering
excellence.

• ADH-3 Adapter (For 1.38” Exit)       588-587

(must be purchased separately)

• ADH-5 Adapter (For 2.0” Exit)         588-2855

(must be purchased separately)

Note: Frequency response and impedance of the DH2T-16 driver attatched to a
25mm (1.0”) diameter plane wave tube, using one watt input (4 Vrms).

Note: Frequency response and impedance of the DH2T-16 driver attached to an
HP64M Horn, measured on axis in the far field using one watt input (4 Vrms).  SPL
calculated to 1 meter equivalent by inverse square law.