Denon AVR-4806CI ユーザーズマニュアル

50

¢ STEREO mode

Use this mode to adjust the tone and achieve the desired
sound.

• The system setup function cannot be used when the PURE

DIRECT mode is set. To use the system setup function,
cancel the PURE DIRECT mode.

• If the HDMI input terminal is selected, video outputs are

outputted in the PURE DIRECT mode.

• The channel level and surround parameters in the PURE

DIRECT mode are the same as in the DIRECT mode.

• The AVR-4806CI is equipped with three 2-channel playback

modes exclusively for music.

• Select the mode to suit your tastes.

¢ PURE DIRECT mode

This mode reproduces the sound with extremely high
quality. When this mode is set, all circuits and processes
not required for the selected input source (FL tube, video
circuit and tone control, as well as digital circuitry and other
unnecessary circuits for analog audio inputs) are
automatically turned off so the music signals can be
reproduced with high sound quality.

The mode switches as shown below each time the
DIRECT/STEREO button on the main unit is pressed.

¢ DIRECT mode

Use this mode to achieve good quality 2-channel sound. In
this mode, the audio signals bypass such circuits as the
tone circuit and are transmitted directly, resulting in good
quality sound.

STEREO

DIRECT

When press SURROUND PARAMETER:
The subwoofer output can be controlled directly.

• When the HOME THX CINEMA button is pressed, the

surround mode is set as follows according to the signal that
is played:

q

THX Surround EX (THX Ultra2 Cinema)

w

Home THX CINEMA (PL

II

x C + THX)

e

THX 5.1

r

ES DSCRT 6.1 +THX, ES MTRX 6.1 + THX

When the HOME THX CINEMA mode is set when a DVD
is played, check the DVD player’s digital output setting and
change the setting to one for which Dolby Digital and DTS
bit stream signals can be output (“bit stream”, for
example).