Emerson EM-250 プリント

1. Keep your 

Bluetooth Headset and mobile phone within 3 feet of each  

    other during pairing.

2. Make sure the 

Bluetooth Headset is turned off.

3. Press and hold the 

[POWER] button until the RED and BLUE lights

    flash alternately.

4. Set the phone to search for bluetooth devices.

5. When the phone finds the headset, confirm by selecting EM252 from the

    list.

EM250 added

1. Place the headset into the dock, and plug the mini USB cable into the back

    of the dock.

2. Connect the USB cable to:

 

● AC Charger, and plug into a wall (A/C) outlet.

● Computer’s USB port.

 

● Car Charger.

3. The RED LED indicator light turns on.

4. The RED LED indicator light shuts off when the headset is fully charged.

    (approximately 2 hours)

NOTE: Make sure you charge your headset for two hours before using it for

            the first time.

Bluetooth

Headset 

and Dock

Owner’s

Manual

USB Cable

Car Charger

Travel Charger

Power ON/OFF

Answer/Reject incoming calls

Dial last number

Volume down/

voice dial

● Check local laws regarding use of a mobile handset and wireless headset

   while driving.  If you use the 

Bluetooth Headset while driving, ensure your 

   attention and focus remains on your driving.

● Observe all signs in the designated areas where some electronic devices 

   or RF radio products are required to be switched off.  These could 

   include airplanes, hospitals, blasting areas, and potentially explosive 

   atmospheres.

Driving while talking on your mobile phone is dangerous, and illegal in 

many states.
Although this device enables drivers to conduct handsfree conversations,

it is still dangerous to drive and use a mobile phone at the same time.  
We recommend pulling over before making or answering calls, especially 

during adverse driving conditions.  Please use your mobile phone, and 

our product responsibly while driving!

This equipment has been tested and found to comply with the requirements 

for a Class B digital device under Part 15 of the Federal Communications 

Commission (FCC) rules. These requirements are intended to provide 

reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to 

radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:
● Re-orient or relocate the receiving antenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit different from that to 

   which the receiver is connected.

consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the

party responsible for compliance could void the user’s authority to operate 

the equipment.

Wireless Headset

Headset and dock