Emerson EM-252 プリント

1. Keep your Bluetooth Headset and mobile phone within 3 feet of each  
    other during pairing.
2. Make sure the Bluetooth Headset is turned off.
3. Press and hold the [POWER] button until the RED and BLUE lights
    flash alternately.

4. Set the phone to search for bluetooth devices.
5. When the phone finds the headset, confirm by selecting EM252 from the
    list.

EM252 added

1. Connect the USB cable to the charging socket on the handset.
2. Connect the USB cable to:

 

● AC Charger, and plug into a wall (A/C) outlet.

● Computer’s USB port.

 

● Car Charger.

3. The RED LED indicator light turns on.
4. The RED LED indicator light shuts off when the headset is fully charged.
    (approximately 2 hours)

NOTE: Make sure you charge your headset for two hours before using it for
            the first time.  

Bluetooth

Headset

Owner’s

Manual

USB Cable

Car Charger

Travel Charger

Power ON/OFF

Answer/Reject incoming calls

Dial last number

Pair

Volume down/

microphone mute

Volume up/

conversation switch/

microphone mute

● Check local laws regarding use of a mobile handset and wireless headset
   while driving.  If you use the Bluetooth Headset while driving, ensure your 
   attention and focus remains on your driving.
● Observe all signs in the designated areas where some electronic devices 
   or RF radio products are required to be switched off.  These could 
   include airplanes, hospitals, blasting areas, and potentially explosive 
   atmospheres.

Driving while talking on your mobile phone is dangerous, and illegal in 
many states.

Although this device enables drivers to conduct handsfree conversations,
it is still dangerous to drive and use a mobile phone at the same time.  

We recommend pulling over before making or answering calls, especially 
during adverse driving conditions.  Please use your mobile phone, and 
our product responsibly while driving!

FCC Part 15
This equipment has been tested and found to comply with the requirements 
for a Class B digital device under Part 15 of the Federal Communications 
Commission (FCC) rules. These requirements are intended to provide 
reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
● Re-orient or relocate the receiving antenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit different from that to 
   which the receiver is connected.
consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the
party responsible for compliance could void the user’s authority to operate 
the equipment.

Wireless Headset