Rocketfish RF-GPS31126 プリント

3 Controls

Note: This headset may also be used with a mobile phone. For pairing and
operating instructions, go to www.rocketfishproducts.com and search for
the Quick Setup Guide for model RF-EX7.

Know the facts
Recharge time: About two hours
Talk time: Up to eight hours
Standby time: Up to 300 hours

LEDs

4 Maintaining

To... Do

this...

Enable or disable the indicator

Press the power button and send/end together.

Check the battery level (method 1) Turn the headset on, then press and release the power button.

Green = Between 1/2 and full charge;

Green then red = Between 1 hour talk time remaining and 1/2 charge;

Red = Less than 1 hour talk time remaining.

Check the battery level (method 2) Turn the headset on. If the indicator flashes red and green, or if it beeps every 5 minutes,

the battery level is low.

Erase paired device information

Turn the headset off, then press and hold the power button and send/end together for about

two

seconds.

Reset

Connect the charger to reset the headset, then user can power on headset after remove the charger.

Green

Power On

Green (fast flashing)

Pairing State

Red (flashing)

Low Battery

RF-EX7

RF-GPS31126

WITH PURE SPEECH®
Hear and be heard like never before

QUICK SETUP GUIDE

To... Do

this...

Mute the microphone

Double-press send/end.

Unmute the microphone Double-press send/end.

To... Do

this...

Increase the volume Swipe upward (toward the ear) on the

touch pad. You will hear a different

“beep” for each level change in volume.

To... Do

this...

Decrease the volume Swipe downward (away from the ear)

on the outside of the headset.

ENGLISH 10-0829

FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.

FCC ID: EMJTRFEX7
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.

Canada IC-RSS210 statement
IC: 4251A-HRFEX7
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.