Jensen CD1213 ユーザーズマニュアル

CD1213

Select

Press the AUDIO
CONTROL

button (4)

to step through the

menu of audio

functions: volume

(VOL), bass (BAS),

treble (TRB), balance

(BAL), fader (FAD),

and volume (VOL). When adjusting audio

functions, the unit will automatically exit select

mode and return to the normal display after five

seconds or when another function is activated.
Bass
Press the AUDIO CONTROL button (4) twice

until “BAS” appears in the display. Within five

seconds, turn the AUDIO CONTROL (3)

clockwise or counter clockwise to adjust the

bass from “-10” to “+10”. “00” represents a flat

response. The bass level is shown on the

display for five seconds or until another function

is activated.
Treble
Press the AUDIO CONTROL button (4) three

times until “TRB” appears in the display. Within

five seconds, turn the AUDIO CONTROL (3)

clockwise or counter clockwise to adjust Treble

from “-10” to “+10”. “00” represents a flat

response. The treble level is shown on the

display for five seconds or until another function

is activated.

Balance
Press the AUDIO CONTROL button (4) four

times until “BAL” appears in the display. Within

five seconds, turn the AUDIO CONTROL (3)

clockwise (or counter clockwise) to adjust

Balance between the right and left speakers

from “BAL 10R” (full right) to “BAL 10L” (full

left). “BAL L=R” represents an equal balance

level between the right and left speakers. The

balance position is shown on the display for five

seconds or until another function is activated.
Fader
Press the AUDIO CONTROL (4) five times until

“FAD” appears in the display. Within five

seconds, turn the AUDIO CONTROL (3)

clockwise or counter clockwise to adjust

balance between the front and rear speakers

from “FAD 10R” (full rear) to “FAD 10F” (full

front). “FAD F=R” represents an equal balance

level between the front and rear speakers. The

fader position is shown on the display for five

seconds or until another function is activated.

Loudness (BAND)

Press and hold

the LOUD/BAND button (5) for

two seconds to activate the LOUD feature.

When listening to music at low volume levels,

this feature will boost the bass and treble

ranges to compensate for the characteristics of

human hearing. When activated, “LOUD”

appears on the display. Press LOUD/BAND

again for two seconds to deactivate this feature.

Audio Mute (MUTE)

Press the MUTE button (6) to mute the audio

volume. “MUTE” flashes on the display. Restore

volume to the previous setting by pressing the

mute button again, adjusting the AUDIO
CONTROL

Equalizer Selector (PEQ)

The equalizer function applies preset sound

effects to the unit’s audio output signal. Press

the PEQ button on the remote control to

activate one of the following operating modes:

FLAT, CLASSICS, POP M, ROCK M or DSP

OFF. When the equalizer function is activated,

the most recently selected bass/treble levels

are ignored. If the bass and/or treble levels are

adjusted while the equalizer function is active,

the equalizer function will revert to FLAT. When

the equalizer function is not active, the unit will

return to the most recently selected bass and

treble levels.

Beep Tone

The beep tone feature allows the selection of

an audible beep tone to be heard each time a

button is pressed on the face of the radio. To

access the Beep Tone menu, press and hold

the AUDIO CONTROL (4). Turn the AUDIO

VOL

VOL

BAS

TRB

BAL

FAD

E
E