Philips PET7402 ユーザーズマニュアル

ページ / 25
Canada
English:
This digital apparatus does not exceed the Class B limits for radio noise emissions 
from digital apparatus as set out in the Radio Interference Regulations of the Canadian 
Department of Communications.This Class B digital apparatus complies with Canadian 
ICES-003.
Français:
Cet appareil numérique n’émet pas de bruits radioélectriques dépassant les limites 
applicables aux appareils numériques de Classe B prescrites dans le Règlement sur le 
Brouillage Radioélectrique édicté par le Ministère des Communications du Canada. Cet 
appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
The set complies with the FCC-Rules, Part 15 and with 21 CFR 1040.10. Operation is 
subject to the following two conditions:
1.  This device may not cause harmful interference, and
2.   This device must accept any interference received, including interference that may 
cause undesired operation.
L’appareil est conforme à la réglementation FCC, section 15, et à la norme 
21 CFR 1040.10. Son utilisation est soumise à deux conditions :
1.  L’appareil ne doit pas provoquer d’interférences nuisibles, et
2.   L’appareil doit supporter les interférences reçues, y compris les interférences 
empêchant son fonctionnement correct.
NOTE:  This equipment has been tested and found to comply with the limits for a Class 
B digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed to 
provide reasonable protection against harmful interference in a residential installation.  
This equipment generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful interference to 
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. 
If this equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to try 
to correct the interference by one or more of the following measures:
• 
Reorient or relocate the receiving antenna.
• 
Increase the separation between the equipment and receiver.
• 
Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected.
• 
Consult the dealer or an experienced radio/TV technician for help.