Radio Shack PLCD41MP ユーザーズマニュアル

ページ / 15
What might seem to be a malfunction in your unit may
just be the result of slight misoperation or miswiring.
Before calling service, first check the following table
for possible problems.
?T he power does not tur n ON.
The fuse has blown.
Install half sleeve, can be with or
?NO Sound.
The cable connect incorrectness.
Exactitude connect of the cable.
?Noise on Radiopoor recepiton
Antenna and Antenna Cable.
Check antenna and antenna cable, the antenna base must be
grounded and connected with good condition, repace
antenna or antenna cable if needed.
?Noise on both Radio and CD
Poor ground,dirty or corroded at the car Battery posts
Check the black wire for proper grounding clean and tighten ground
connection.
?No/Poor sound on one or more speakers
Speakers or speaker wiring or volume, Balance and
Fader setting
Check the speaker wiring and test the speakers all in good condition
check the setting of volume, Balance and Fader controls.
?CD sound skips
Installation the unit angle is greater than 45
,or
mounting is not fixed and the back strap is not secure.
Adjust the unit with mounting angle less than 45
and make sure the
unit is mounted securely and tighten with the back strap(supplied)
?Unit completely inoperative, no Light and Sound
Incorrect wire connection, Power RED/YELLOW or
Ground wire or Blown fuse
Check the Red wire to +12 Volts with key lgnition witch, yellow wire to
+12 Volts battery and black wire to ground. Check Fuse with red/yellow
wire, or check the fuse block on your car.
13