JVC UX-QD70W ユーザーズマニュアル

ページ / 82
Introduction
77
Troubleshooting
Check the following points before contacting the JVC service center.
If this product does not function properly even after you have implemented the possible 
solutions given above
Many functions of this product are implemented by microcomputers. If malfunction is caused by 
thunder or static electricity, or the main unit does not function properly even when you press a 
button, disconnect the power plug from the AC outlet, wait for a while, and then connect this 
product again. Then reset the clock.
Problem
Possible cause
Possible solution
Reference 
page
No sound/video is 
produced. 
Improper connection.
Connect all cords properly as in 
"Connections".
10-15
Headphones are connected.
Disconnect the headphone plug.
7
The clock display is 
flashing.
A power failure occurred or the 
power plug was disconnected.
Reset the clock. 
16
Disc playback does not 
start.
The disc is upside down.
Place the disc on the disc tray with 
the letter-printed surface facing up.
22
Moisture has condensed on the 
lens.
Leave the main unit turned on, wait 
for approximately 1 or 2 hours, and 
then operate the main unit.
3
A certain point cannot be 
played back properly.
The disc is scratched or dirty.
Clean or replace the disc.
75
An error occurred on the MD.
Record to the MD again.
51
The volume of cassette 
tape playback is low.
The head or capstans are dirty.
Clean the head or capstans.
75
You cannot record an 
MD/cassette tape.
The MD/cassette tape is write-
protected.
Cancel the write-protection.
55, 75
A radio broadcast cannot 
be received.
No antenna is connected.
Connect an antenna. 
10
A whirring noise is 
produced.
The main unit is located close to a 
TV, computer, or other electric 
appliance.
Place the main unit away from a TV, 
computer, or other electric appliance. 
3
The timer does not work.
You did not set the clock.
Set the clock.
16
The main unit is turned on.
After setting the timer, turn off the 
main unit.
69, 71
You cannot operate the 
remote control.
The remote control batteries are 
running low.
Replace the batteries with new 
batteries.
8
You cannot operate the 
main unit with the number 
buttons on the remote 
control. 
The remote control mode selector 
on the remote control is set to TV. 
Set the remote control mode selector 
to AUDIO. 
16
A noise comes from the 
rear of the main unit. 
The internal cooling fan produces 
a noise as it rotates. 
The noise is not a malfunction. This is 
to prevent excessive heat. 
12
UX-QD70[UB]-05.fm  Page 77  Monday, September 12, 2005  2:36 PM