ZyXEL Communications P-660H-TX ユーザーズマニュアル
P-660H-Tx v2 Support Notes
Connect the LAN ports of all computers to the LAN Interface of P-660H-Tx v2
using Ethernet cable.
using Ethernet cable.
(2) TCP/IP configuration
Since the P-660H-Tx v2 is set to DHCP server as default, so you need only to
configure the workstations as the DHCP clients in the networking settings. In
this case, the IP address of the computer is assigned by the P-660H-Tx v2.
The P-660H-Tx v2 can also provide the DNS to the clients via DHCP if it is
available. For this setup in Windows, we check the option 'Obtain an IP
address automatically' in its TCP/IP setup. Please see the example shown
below.
configure the workstations as the DHCP clients in the networking settings. In
this case, the IP address of the computer is assigned by the P-660H-Tx v2.
The P-660H-Tx v2 can also provide the DNS to the clients via DHCP if it is
available. For this setup in Windows, we check the option 'Obtain an IP
address automatically' in its TCP/IP setup. Please see the example shown
below.
Set up your P-660H-Tx v2 under routing mode
The following procedure shows you how to configure your P-660H-Tx v2 as
Routing mode for routing traffic. We will use Web Configurator to guide you
through the related menu.
Routing mode for routing traffic. We will use Web Configurator to guide you
through the related menu.
(1) Configure P-660H-Tx v2 as routing mode and configure Internet setup
parameters in Web Configurator, Advanced Setup, Network -> WAN ->
Internet Connection.
parameters in Web Configurator, Advanced Setup, Network -> WAN ->
Internet Connection.
Key Settings:
30
All contents copyright © 2006 ZyXEL Communications Corporation.