Arcam DT91 ユーザーズマニュアル

ページ / 52
DT91
E-6
E
n
g
li
s
h
DT91
E-7
Using your tuner
Searching for radio stations: DAB
When using the DAB tuner section for the fi rst time, you should perform a search to fi nd the available 
services in your area. You may also wish to repeat the search periodically to discover if any new 
ensembles (i.e. groups of services) have gone on air, or if you move the tuner to a different area.
To perform a search
Ensure that the DT91 is in DAB mode (by pressing the DAB/FM button until ‘DAB’ is shown on the 
display), then press 
SEARCH
 or 
MENU
; the display shows ‘DAB Setup: Press SELECT to scan’. Press 
SELECT
 to start searching for new stations. The current search frequency is shown on the display as the 
search progresses.
A complete search may take three minutes or so to complete. You cannot cancel a search once started.
If no service is found after the search, then either your aerial is inadequate or you may be outside of the 
area covered by DAB broadcasts. Please contact your Arcam dealer for further information or advice.
Selecting a service
Turn the rotary controller (or press 
4
 or 
3
 on the remote control) to work through the available 
stations and to choose the one you wish to listen to. The service displayed will be selected automatically 
after a delay of about two seconds.
Deleting services
Under normal circumstances, you should not need to delete services from the DT91. If you move to a 
different region, however, or if a station ceases transmission, stations may be shown as available that 
can no longer be received.
Individual stations cannot be deleted. To remove stations from the selection list that can no longer be 
received, fi rst press the 
MENU
 button; the display shows ‘DAB Setup: Press SELECT to scan’. Turn the 
control knob until the display shows ‘DAB Setup: Press SELECT to erase’, then press 
SELECT
. All services 
are deleted.
A delete operation should always be followed by a search for available stations (as described previously) 
otherwise no DAB radio stations will be available for selection.
POWER
DT91 FM + DIGITAL RADIO TUNER
STORE
1–8
STORE
9–16
SEARCH
DISPLAY
MODE
DAB/FM
MENU
SELECT
1–9
5–13
2–10
6–14
3–11
7–15
4–12
8–16
Front-panel controls
SEARCH
In DAB mode, pressing 
SEARCH
 scans for new 
DAB radio stations. See 
‘Searching for radio 
stations: DAB’, for 
further information.
POWER
This switches the tuner 
on and off. When the 
tuner is switched on 
the status LED is green.
DAB/FM
Switches between DAB 
and FM mode.
DISPLAY MODE
Press this button to change 
the type of information 
shown on the display (such 
as scrolling text or signal 
strength).
Control knob
In DAB mode, rotate the 
control knob to cycle 
through stations until the 
one you wish to listen 
to is displayed. In FM 
mode, rotating the control 
knob changes the tuning 
frequency.
SELECT
The 
SELECT
 button 
confi rms an action 
within the confi guration 
menu. 
MENU
Opens the confi guration 
menu for the DT91. See 
the sections ‘Searching 
for radio stations: DAB’ 
and “Searching for radio 
stations: FM”, for further 
information.
Preset station selection
These buttons allow quick 
selection of up to 16 preset 
radio stations. For a preset 
between 1 and 8, press 
and release
 the appropriate 
button – for a preset 
between 9 and 16, press and 
hold
 the appropriate button.
STORE 1–8, STORE 9–16
These buttons are used 
when specifying a preset 
location (1–8 or 9–16) to 
store a radio station. See 
‘Programming a preset 
radio station’, for further 
information.