ONKYO TX-NR1007 ユーザーズマニュアル

Notes:
• See page 27 for charts showing how the “Monitor

Out” and “Resolution” settings affect the video signal
flow through the AV receiver.

• This procedure can also be performed on the AV

receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.

Use the Up and Down [

q]/[w] but-

tons to select “Resolution”, and
use the Left and Right [

e]/[r]

buttons to select:

Through:

Select this to pass video through the
AV receiver at the same resolution
and with no conversion.

Auto :

Select this to have the AV receiver
automatically convert video at reso-
lutions not supported by your TV.

480p (480p/576p):

Select this for 480p or 576p output
and video conversion as necessary.

720p:

Select this for 720p output and
video conversion as necessary.

1080i:

Select this for 1080i output and
video conversion as necessary.

1080p :

Select this for 1080p output and
video conversion as necessary.

Source:

Output will be according to the res-
olution level which was set in the
“Picture Adjust” setting (see
page 100).

Tips:
• The “Resolution” setting can also be

set using the [VIDEO] button on the
remote controller.

• The “Resolution” setting is set

respectively of main, sub, and
analog.

Notes:
• Settings marked with an asterisk ( )

are not available when the “Monitor
Out” setting is set to “Analog”.

• If the “Monitor Out” setting is set to

“Both”, this setting is fixed at
“Auto”.

Press the [SETUP] button.
The setup menu closes.