Sharp CX68RF5 ユーザーズマニュアル

D i m e n s i o n :   1 7 6   x   2 5 0   m m

M & M   P r i n t e r s   S d n .  B h d

C X 6 8 R F 5 _ 0 1 - 0 9 E

With the number buttons (on remote control)

• To select a one-digit channel, such as 5, press 

.

If “5-” is indicated, press 

 to select one-digit input, and then

press 

 again.

• To select a two-digit channel,

such as 15, press 

 to

select the two-digit input. Press

, and then press

.

• When the   Standby indicator is red, either 

 / 

 on the TV can be pressed to turn on

the power.

• The channel number is displayed in green for channels tuned by auto tuning and displayed in yellow for

channels tuned using fine tuning.

• When the   Standby indicator is red, the TV is in Standby mode and power is still supplied to the TV. If

you will not watch TV for a while, turn off the main power by pressing 

 on the TV set. Also, if

you will not be at home for a considerable length of time, unplug the cord from the outlet.

• The AV1 (or SAV1), AV2 (or COMPONENT) and AV3 (or SAV3) input channels can be selected using

.

• Channels that have been skipped cannot be selected by 

 / 

. See 

.

• The on-screen displays in this manual may differ from their actual appearance.

• When the   Standby indicator is off, press 

.

• When the   Standby indicator is red, press 

 on the remote

control. The   Standby indicator changes to green and a picture
appears.

With 

 / 

• Press 

 and channels change as shown below.

1 / 2 / ... / 98 / 99 / AV1 (or SAV1) / AV2 (or COMPONENT) /
AV3 (or SAV3) / 0 / 1 / 2 ...

• Press 

 and channels change as shown below.

1 / 0 / AV3 (or SAV3) / AV2 (or COMPONENT) / AV1 (or SAV1) /
99 / 98 / ... / 2 / 1 / 0 ...

• The volume bar disappears

approximately five seconds
after the volume has been
adjusted.

Standby indicator