Mitsubishi Electronics MR-J3 ユーザーズマニュアル
15 - 41
15. COMMUNICATION FUNCTION
(e) Dwell
Read the dwell of the point table.
1) Transmission
1) Transmission
Transmit command [6][0] and any of data No. [0][1] to [F][F] corresponding to the point table to be
read. Refer to section 15.4.1.
read. Refer to section 15.4.1.
2) Reply
The slave station sends back the dwell of the requested point table.
0
Hexadecimal data
Display type
0: Used unchanged in hexadecimal
1: Conversion into decimal required
Dwell write type
0: Valid after write
1: Valid when power is switched on again after write
0: Used unchanged in hexadecimal
1: Conversion into decimal required
Dwell write type
0: Valid after write
1: Valid when power is switched on again after write
0
0
(f) Auxiliary function
Read the auxiliary function of the point table.
1) Transmission
1) Transmission
Transmit command [6][4] and any of data No. [0][1] to [F][F] corresponding to the point table to be
read. Refer to section 15.4.1.
read. Refer to section 15.4.1.
2) Reply
The slave station sends back the auxiliary function of the requested point table.
0
Hexadecimal data
Display type
0: Used unchanged in hexadecimal
1: Conversion into decimal required
Auxiliary function write type
0: Valid after write
1: Valid when power is switched on again after write
0: Used unchanged in hexadecimal
1: Conversion into decimal required
Auxiliary function write type
0: Valid after write
1: Valid when power is switched on again after write
0
0