Carson 1022-10 ユーザーズマニュアル

ページ / 16
Page 4 of 16 
SC-1002 / 1012 / 1022-10 14  Installation Instructions 
2/20/08 
CP4997B 
 
INSTALLATION 
Proper installation of the unit is essential for years of safe, reliable operation.  Please read all 
instruction before installing the unit.  Failure to follow these instructions can cause serious dam-
age to the unit or vehicle and may void warranties. 
SAFETY PRECAUTIONS 
For the safety of the installer, vehicle operator, passengers and the community please observe 
the following safety precautions.  Failure to follow all safety precautions and instructions may 
result in property damage, injury or death.
 
Qualifications - The installer must have a firm knowledge of basic electricity, vehicle electrical 
systems and emergency equipment. 
Hand Control Location - Locate the hand control for easy access by the vehicle operator. DO 
NOT locate in air bag deployment area 
Mounting
 - Mount the unit for easy access by the vehicle operator.  DO NOT mount in air bag 
deployment area.  Assure clearances before drilling in vehicle. 
Wiring - Use wiring capable of handling the current required.  Make sure all connections are tight.  
Route wiring to prevent wear, overheating and interference with air bag deployment.  Install and 
check all wiring before connection to vehicle battery. 
Testing - Test all siren functions after installation to assure proper operation.  Test vehicle opera-
tion to assure no damage to vehicle. 
Keep These Instructions - Keep these instructions in the vehicle or other safe place for future 
reference.  Advise the vehicle operator of the location. 
 
 
 
 
UNPACKING 
Inspect contents for shipping damage.  If found alert carrier immediately
Contact supplier immediately if any items are missing. 
Contents of box should include the following items: 
Sound Hazard - Sound level from siren speaker (>120dBA @ 10 feet) may cause hearing damage. 
Do not operate siren without adequate hearing protection for you and anyone in immediate vicinity. 
(Ref. OSHA 1910.95 for occupational noise exposure guidelines) 
Item SC-1002 
SC-1012 
SC-1022 
Bracket, ‘U’ Dash Mount   (CP3571) 
Mounting Bracket Hardware   (ED1608 Hardware Kit) 
(Kit contains 2  Bolts,  2  Nuts,  and 4  Lockwashers) 
X X X 
Connector, 6-P Terminal Block Plug   (CP4956-06) 
Terminal, 3/16” Insulated Female Q.C.   (CP4062-K2523) 
 
 
Velcro Strip Fastener   (VELCRO) 
 
 
Instruction Manual   (CP4997   This Manual) 
Hand Control Assembly   (SC-1022-10CH) 
 
 
Remote Panel Assembly   (SC-1012-10CH) 
 
 
Console Unit   (SC-1002-10 14) 
 
 
Remote Amplifier   (SC-1000-10 14) 
 
Connector, 10-P Terminal Block Plug   (CP4688-10) 
 
 
Qty 






20