Panasonic CQ-R221U ユーザーズマニュアル
CQ-R221U
16
E
N
G
L
I
S
H
7
Cassette Tape Player Basics
continued
TPS Operation (Tape Program
Search)
Search)
Press [3] (TPS) to activate the tape program search mode.
From the current selection, decide which program you want to
select. Now, press [
select. Now, press [
] several times forward (up to 9
programs) or press [
] several times backward (up to 8 ) to
select the corresponding program number.
EX1. To select the current program
again press [3] (TPS), and press
[
[
] once.
EX2. To select the 1st program
backward of the current selection,
press [3] (TPS) once, and press
[
press [3] (TPS) once, and press
[
] two times.
EX3. To select the next program, press
[3] (TPS) and press [
] once.
EX4. To select the 3rd program forward
of the current selection, press [3]
(TPS) once, and press [
(TPS) once, and press [
]
three times.
To turn it off, press [3] (TPS) again.
(Rewind:)
8
0
c
(Fast forward:)
1
9
c
Note:
The TPS mode may not work correctly in the following cases. This, however, does not mean that
the unit is defective.
The TPS mode may not work correctly in the following cases. This, however, does not mean that
the unit is defective.
●
There is an interval less than 4 seconds or having a high level of noise or hum between
programs.
programs.
●
There is particularly low-level passage during the program.
Notes:
●
To maintain your cassette player in top condition, avoid using tapes that are longer than 90
minutes (C-90).
minutes (C-90).
●
If you insert into the unit a cassette with a loose tape caused by forcing it into cassette with a
finger or the like, the cassette may not be properly reproduced. In such a case, eject the
cassette, make the tape tight, then insert it back into the deck.
finger or the like, the cassette may not be properly reproduced. In such a case, eject the
cassette, make the tape tight, then insert it back into the deck.
Notes on Cassette Tapes
Pencil
Do not touch
or pull out
the tape.
or pull out
the tape.
Tape Slack:
Use a pencil or similar object to take up the slack
as shown. If a loose tape is used, this may result
in the tape becoming tangled in the rotating
parts of the unit.
Use a pencil or similar object to take up the slack
as shown. If a loose tape is used, this may result
in the tape becoming tangled in the rotating
parts of the unit.
S•HDB
S•HDB
d
or