Metra Electronics 99-5803 プリント

Locate the factory wiring harness in the 
dash.  Metra recommends using the 
proper mating adaptor and making 
connections as shown.  (Isolate and 
individually tape off the ends of any 
unused wires to prevent electrical short 
circuit).

Re-connect the battery terminal and test the unit 
for proper operation.  Mount the  Rear Support 
Bracket to the back of the DIN cage.  Slide the 
cage into the mounted Radio Housing and 
secure by bending the metal locking tabs down.  
Slide the aftermarket head unit into the mounted 
cage until secure.

MUSTANG:  Mount the  Radio Housing to the sub-dash with (2) 7mm hex-head screws 
previously removed in step #1  (Fig. A).
COUGAR:  Snap the  Radio Housing into the sub-dash   (Fig. B).

Disconnect the negative battery terminal to 
prevent an accidental short circuit.  Unclip the 
gear shifter trim and remove.  Unclip the 
radio/climate control trim bezel and remove.  
Remove (2) 7mm hex-head screws from the 
factory head unit and disconnect the wiring.

FORD Mustang  2001-03

MERCURY Cougar  1999-02

Locate the Radio Housing.  Skip to the 
Installation Instructions for ALL VEHICLES 
on Page #2.

Cut and remove tabs "A" from the Radio 
Housing.  Skip to the Installation 
Instructions for ALL VEHICLES on Page #2.

Disconnect the negative battery terminal to 
prevent an accidental short circuit.  Using 
Metra's 86-5618, pull the factory head unit 
from the dash and disconnect the wiring.

ALL VEHICLES