ONKYO CR-545 CR-545UKD ユーザーズマニュアル

27 

Make sure the slot 
is at the rear.

When you select iPod as the input source, the headphones output no sound. If use headphones, connect it directly 
to iPod. 
Before using your iPod with the CD receiver, be sure to update your iPod with the latest software, available from 
the Apple Web site. 
If you leave your iPod paused when using it on its own, eventually it will go into hibernation. If you insert it into 
the CD receiver dock in this state, you’ll need to wait a few moments before your iPod is ready for use. 
Always remove your iPod before moving CD receiver. 
Depending on your iPod, or the type of content being played, some functions may not work as expected. 
 

First, with the adapter slot facing the back, fit in the front of the adapter and then press in the back until a click is 
heard. To remove the adapter, lift the back side up. If the adapter is difficult to remove, insert a thin object into 
the slot and lift the adapter up. 
Always use the Universal Dock Adapter enclosed with the iPod model to correctly set the iPod in the CD 
receiver.  
 
Note: 
The slot’s connection terminal could be damaged if the iPod is set in the CD receiver dock without using the 
Universal Dock Adapter. 
Please purchase a commercially available dock adapter when using an iPhone 
or when the Universal Dock Adapter has been lost or damaged. 
 
 
 

 

Raise the dock cover, insert your iPod 
ensuring that it is seated correctly. 
 
Notes: 
•    The appropriate iPod universal dock 

adapter must be installed prior to inserting 
an iPod. 

•    To prevent damage to the dock connector, 

do not twist or force your iPod into the 
dock, and be careful not to wiggle your 
iPod while inserting it. 

•    Do not use with any iPod accessories, 

such as FM transmitters and microphones, 
as they may cause a malfunction. 

•    If you use a case with your iPod, always 

remove it before you insert it. 

 

Otherwise, it will not connect properly 
and a malfunction may occur. 

select “iPod”. 
When no iPod is connected, “iPod No 
Device” will be displayed.

button. 
Playback will begin. 

To pause playback: 
Press the [

] button. The Pause 

 

indicator appears. To resume playback, press 
the [

] button again.

 

•    You can see the contents of “videos” and 

“photos” in your iPod on TV (see page 17). 

 

Confirm your iPod, if video output is available. 

•    The volume level is adjusted by using the 

VOLUME [ ] / [ ] knob or the buttons on the 
remote controller. 
Adjusting the volume on your iPod has no effect. 
In case you inadvertently move your iPod 
volume control, make sure the volume level is 
not set too high before you reconnect your 
headphones.