Sony 3-869-888-16 (1) ユーザーズマニュアル
140
Chapter 5 Settings
Note
The pre-alarm, alarm, and post-alarm periods have the following
relationship.
relationship.
1
Pre-Alarm Period
The period of time before the alarm occurred, as set in
[Duration] under [Pre Alarm].
The period of time before the alarm occurred, as set in
[Duration] under [Pre Alarm].
2
Alarm Period
The alarm signal is active during this period.
The alarm signal is active during this period.
3
Post-Alarm Period
The period of time after the alarm is stopped, as set in
[Duration] under [Post Alarm].
The post-alarm period can be set as the period starting from
either the point the alarm is triggered or the point the alarm
ends.
The period of time after the alarm is stopped, as set in
[Duration] under [Post Alarm].
The post-alarm period can be set as the period starting from
either the point the alarm is triggered or the point the alarm
ends.
4
Alarm Triggered
The alarm signal was activated at this moment.
The alarm signal was activated at this moment.
Inputs
Configure properties relating to the input source.
Configure properties relating to the input source.
Sensor Input
If you want to select a sensor input name as a trigger for
alarm recording, select this check box and then select a
sensor input name.
You can select multiple sensor input names.
When the [Show all] check box is selected, all the sensor
inputs enabled for the camera are displayed. When the
check box is cleared, only the sensor inputs for the targeted
camera are displayed.
The sensor input names of all cameras and the NSR are
available for selection if [Enable] is set for them.
If you want to select a sensor input name as a trigger for
alarm recording, select this check box and then select a
sensor input name.
You can select multiple sensor input names.
When the [Show all] check box is selected, all the sensor
inputs enabled for the camera are displayed. When the
check box is cleared, only the sensor inputs for the targeted
camera are displayed.
The sensor input names of all cameras and the NSR are
available for selection if [Enable] is set for them.
VMD (Recorder)
Select this check box to select motion detection as a trigger
for alarm recording.
You must configure the motion detection settings to use
this function.
Select this check box to select motion detection as a trigger
for alarm recording.
You must configure the motion detection settings to use
this function.
Caution
When configuring a schedule for multiple cameras, unlike
sensor inputs, each camera’s own motion detection is
treated as an input.
sensor inputs, each camera’s own motion detection is
treated as an input.
Video Motion Filter
To select a VMF package as the trigger for alarm recording,
select this check box and then select a VMF package.
To select a VMF package as the trigger for alarm recording,
select this check box and then select a VMF package.