JAI CV-A33CL ユーザーズマニュアル

 

- 18 - 

 

 
User ID. 
The command (UD) the user can save up to 16 characters in the camera to identify the camera.  
 

Bit Allocation. 
The command (BA) will select the number of bits in the Camera Link output to 8 or 10 bit. 
 
Black Level.  
The command (BL) is for adjusting the video black level (or set-up level). 
 
GAin level. 
The command (GA) is for adjusting the gain level between 0 and 15 dB. 

 
CaliBration of CMOS sensor. 
This command (CB=0) will calibrate all the A/D converters on the CMOS sensor. The calibration 
procedure for gain and offset is done automatically each time the command is received and at 
power up. Allow the camera to warm up before the calibration is done. 
The data from the calibration can be stored in a file by the camera control tool by the command 
“Read Calibration” and “Write to File”. With the command “Read from File” the calibration data 
can be loaded to the camera and used as calibration.  

 

Important notes on using this function.

 

•  “Read Calibration” takes about 22 seconds. 
•  “Read from File” takes about 45 seconds. 

 

 
SW 200 is for selecting the RS232C input through Camera Link or the 12 pin HR connector. 
SW 200 is placed inside on the camera motherboard PK8387B near the rear. 
SW 300 is for 75 Ω terminating of the trigger input on pin #10 on 12 pin HR connector. 
SW 300 is placed inside on the rear board PK8388B. (On for 75 Ω terminating.) 
 
 

SW 200

On

Off

CL          HR

SW 200

On

Off

CL          HR

SW 300

On

Off

Trig. Pin #10

1  2

SW 300

On

Off

Trig. Pin #10

1  2

 
 

 
 
 
 
 
 
 
 

 

 

 

Fig. 24. Internal switch setting