JAI TS-1327EN ユーザーズマニュアル

 

 

 

 

 

35 

camera settings should already be correct for the site installation, but it is a good idea to verify that 
this is true before proceeding. The Setup Computer is now properly configured to support lens 

adjustments and camera aiming. 

•  Position the Setup Computer next to the camera being aligned. If the alignment is conducted in 

bright sunlight, shield the monitor screen with a hood to make it visible. Make sure that no 
portion of the computer or cables interfere with the camera’s view of the road. 

•  Connect the Setup Computer’s network adapter with the camera network. This can be done 

directly to the I/O boards X1 and X3 connectors or using a local Ethernet switch. It is preferable 
to use a local Ethernet switch instead of a local direct connection to the I/O board. A direct 

connection between the Setup computer and the camera will disconnect the camera from the 
site LAN and thereby disconnect the light sensor as well. 

 

The network connection between the Setup computer and the camera can be established using a 

local switch. Two separate ports of the Ethernet Switch are connected directly to the I/O board 
connectors X1 and X3. The Setup computer is then also connected to one of the free ports on the 

switch. If the switch is running on 24V dc, the I/O board is capable of supplying up to 0.5A on 
connector X15 located next to X1 and X3. The pin marked with #1 on X15 is +24V dc.