Intellinet Network Solutions UNC-W10 ユーザーズマニュアル

 

This information explains instructions in detail on how to set the default settings in the Wireless 

Network IP Camera. In certain circumstances it may become necessary to restart or reinstate the 

Factory Default settings for your Wireless Network IP Camera: This is performed by pressing the 

Reset Button, or using Hyper Terminal Setting. Follow these instructions to reinstate the product 

factory default settings 

 

 

①  Using a paper clip or any sharp pin, press the reset button on the backside of Wireless 

Network IP Camera. 

②  Switch off the Wireless Network IP Camera by disconnecting the power cable. 

③  Press and keep the Reset Button pressed, and then reconnect the power supply cable. 

④  Keep the Reset Button pressed until the Operating Status LED (Green) blinks three times. 

(Note that this may take up to 10~15 seconds), then release the button. When the 

Operating Status LED (Green) blinks three times. 

 

       

①  Execute “Hyper Terminal” as 

referred to Chapter “4.3.1 

Configuring Hyper Terminal”   

②  Supply the power to the Wireless 

Network IP Camera. 

③  After a while, the count down 

starts with the message   

“Press 'p' key to stop auto-boot or 

NetCam for 3 seconds...” 

.At this time, press ‘p’ key. Then, 

[Wireless Network IP Camera Boot] 

prompt shows like the right side 

image. 

④  When you enter ‘w’, Administrator ID & Password reinstate as factory default ‘admin’ 

 

 

 

 

77