Panasonic WV-NW474S ユーザーズマニュアル

-31-

Symptom

No picture is displayed.

HTML documents are not displayed.

• Is the 24 V AC cable firmly connected?
• Is the video cable or network cable connected properly? 

• HTML files in the camera might be broken. Initializing is

required.

12

30

Cannot access the camera from the
browser.

• Are the network cables connected properly?
• Is the status indicator lamp of the network connection termi-

nal on?
If not, a network connection has not been established or the
other devices are not in operation.

• Is a valid IP address set for the camera?
• Are you connecting to a wrong IP address?

Open the command prompt on your PC and enter: 
>ping (enter here the IP address set for the camera). 
If the camera replies, the connection is correct. 
If not, set the correct IP address for your PC and/or to the
camera.

12, 16-19

What to do

Reference page

You can reset the following data back to the factory
default settings.

Camera Setup
Setup Menu (PC oriented)
HTML files

■

• Move the cursor to CAMERA RESET.
• Hold down [Left], [Right], and [SET] buttons simulta-

neously for 2 seconds on the camera, or click the All
Reset button on your computer display.

■

• In the power-on state, press the [Up] and [Down]

buttons simultaneously while holding down the but-
ton A.
Hold down the button A for 15 seconds. It will take
about 10 seconds to complete the initializing. Be
sure to continue supplying power to the camera
while initializing.

• Clock calibration is required even after initializing

the setup menu.

• Try again if the previous initializing failed.

■

• In the power-on state, press the side panel buttons,

[Up] and [Down] simultaneously while holding down
the button B.
Hold down the button B for 15 seconds. It will take
about 10 seconds to complete the initializing. Be
sure to continue supplying power to the camera
while initializing.
Notes:

• Never press both the buttons A and B at a time.
• Try again if the previous initializing failed.