VIVOTEK PT8133 ユーザーズマニュアル

 

 

ADSL/Cabl

e/Hub

12V

1.5A

ETHERNE

T

WPS

 

1. Make sure your AP (Access Point) and Operating System support WPS (Wi-Fi Protected Setup) 

functions. WPS enables easy setup with compatible APs. 

3. The camera's blue LED should start flashing. Press and hold down both of the WPS buttons on 

your AP and your camera for at least 1 second. (Some router/AP will have a virtual button on their 

management software instead.) Refer to your AP's documentation for details using its WPS function.

If your AP does not support WPS, configure your wireless connection manually.  

When WPS configuration is done, wireless connectivity will be established and the security encryption, 

such as WEP or WPA-PSK, will be synchronized with the AP. Use the IW2 utility to find the camera. As 

for IP setting, the camera's use of DHCP or static IP is determined by your configuration on the network 

camera via the web-based configuration of firmware. The camera's default is DHCP.    

WPS buttons

Wireless AP

2. Connect your camera using a LAN cable, open a web console, and enter the 

Configuration -> 

Wireless page. Select the WPS checkbox, and click the Save button. 

4. Wait for 2 minutes with the onscreen progress bar. The camera should then reboot.When the progress 

bar disappears, disconnect your LAN cable. You can refresh or re-start your web console to see live 

video.