VIVOTEK IP8161 ユーザーズマニュアル

 

 

 

 

This section explains how to control the Network Camera’s Pan/Tilt/Zoom operation� 

There are two ways to enable the camera control function:

1� Mechanical: Connect the Network Camera to a PTZ driver or scanner via RS485 interface�

2� Digital: Control the e-PTZ operation� It allows users to quickly move the focus to a target 

area for close-up viewing without moving the camera physically� Please refer to page 75 for 

detailed instruction�

If you select “Mechanical“, the RS485 Settings section will be displayed as shown below:

Disable: Select this option to disable this function�

PTZ camera: Select this option to enable PTZ operation� 

To utilize this feature, please connect the Network Camera to a PTZ driver or scanner via RS485 

interface first. Then you can configure the PTZ driver and RS485 port with the following settings.

VIVOTEK offers three PTZ drivers: DynaDome/SmartDOME, Lilin PIH-7x00, and Pelco D protocol� 

If none of the above PTZ drivers is supported by your PTZ scanner, please select 

Custom camera 

(scanner)� Please refer to the user’s manual of your PTZ scanner to determine the Camera ID, PTZ 

driver, and Port settings� The Camera ID is necessary to control multiple cameras� If you click 

Save to 

enable this function, the camera control panel will be displayed on the main page� Please refer to the 

illustration on page 72�