JVC 137 ユーザーズマニュアル

Setting Tampering Detect Sensitivity

Format /api/param?camera.detection(tampering).temporal=data

Example of response camera.detection(tampering).temporal&202 Accepted(camera.status=save)

Interpretation Change the tampering detect time. Specify a value between 0 to 120. The change is saved by the

API, camera.status=save. If the change is not saved, the setting is restored by reboot.

Allowed users admin, operator

19. JVC API for Network Basics

The APIs below are related to the basics of networks. These are equivalent to the features on the Basic page of

the WEB setting page. Refer to the instruction manual for details on the Basic page.

Enabling Network Setting Changes

Format /api/param?network.interface.status=restart

Example of Response network.interface.status&200 OK

Interpretation Changes of following network parameters become valid by this API.

DHCP, IP Address, Subnet Mask, TTL, MTU, TOS, Negotiation, IPv6

Changes are not reflected in the actions until this API is used. APIs to get settings of those parameters return

previous values until this API is used. When this API is issued, the camera reboots in about 1 minute.

Allowed user admin

Getting DHCP Setting

Format /api/param?network.interface.dhcp.status

Example of Response network.interface.dhcp.status=off&200 OK

Interpretation Acquire the current DHCP setting.

Allowed users admin, operator, user

Setting DHCP

Format /api/param?network.interface.dhcp.status=data

Example /api/param?network.interface.dhcp.status=on

Example of Response

network.interface.dhcp.status&202 Accepted(network.interface.status=restart)

Interpretation Change the DHCP setting. Specify "on" or "off". To validate the change, use

"network.interface.status=restart" API that reboots the camera in about 1 minute.

Allowed user admin