VIVOTEK IP3137 ユーザーズマニュアル

 

 

 
 

 
 
 

 

  

www.vivotek.com 

 

 

 

 
 

After powering up, the Network Camera performs a self-diagnostic to detect any 
hardware defects. The following table lists the LED patterns in general. In case of any 
fatal error, the LED will blink in a pattern other than those below. 

Condition LED 

color 

During self-diagnostic after power on 

Blink in interchanged blue and red 

Ethernet signal is lost 

Steady red till Ethernet is detected 

Before network is setup 

Steady blue till IP address is confirmed 

After network is setup 

Blink blue every second 

Network is setup and audio is disabled 

Blink blue every 4 seconds 

Any hardware failure 

Other patterns 

 
 
 
 

There is a 

button in the back of the Network Camera. It is used to reset 
the system or restore the factory default settings. 
Sometimes resetting the system sets the system back to 
normal state. If the system problems remain after reset, 
restore the factory settings and install again. 
RESET: Click on the button. 
RESTORE:    
1. Press on the button continuously. 
2. Wait for self-diagnostic to run twice. 
3. Free the button as soon as the second self-diagnostic        
starts.    

 

Restoring the factory

defaults will erase any previous
settings. Reset or restore the
system after power on.