ZyXEL Communications 3.1 ユーザーズマニュアル

 Chapter 38 System Remote Management

ZyWALL (ZLD) CLI Reference Guide

The following table describes the commands available for SNMP.

 

You must use the 

configure 

terminal

 command to enter the configuration mode before you can use these commands.

 

The following command sets a service control rule that allowed the computers with the IP 
addresses matching the specified address object to access the specified zone using SNMP service.

Command Summary: SNMP

[no] snmp-server

Allows SNMP access to the ZyWALL. The 

no

 command disables 

SNMP access to the ZyWALL.

[no] snmp-server community community_string 

{ro|rw}

Enters up to 64 characters to set the password for read-only 
(ro) or read-write (rw) access. The 

no

 command resets the 

password for read-only (

ro

) or read-write (

rw

) access to the 

default.

[no] snmp-server contact description

Sets the contact information (of up to 60 characters) for the 
person in charge of the ZyWALL. The 

no

 command removes the 

contact information for the person in charge of the ZyWALL.

[no] snmp-server enable {informs|traps}

Enables all SNMP notifications (informs or traps). The 

no

 

command disables all SNMP notifications (informs or traps).

[no] snmp-server host {w.x.y.z} 

[community_string]

Sets the IPv4 or IPv6 address of the host that receives the 
SNMP notifications. The 

no

 command removes the host that 

receives the SNMP notifications.

[no] snmp-server location description

Sets the geographic location (of up to 60 characters) for the 
ZyWALL. The 

no

 command removes the geographic location for 

the ZyWALL.

[no] snmp-server port <1..65535>

Sets the SNMP service port number. The 

no

 command resets 

the SNMP service port number to the factory default (

161

).

snmp-server rule {rule_number|append|insert 

rule_number} access-group {ALL|address_object} 

zone {ALL|zone_object} action {accept|deny}

Sets a service control rule for SNMP service.

: The name of the IP address (group) object. 

You may use 1-31 alphanumeric characters, underscores(

_

), or 

dashes (-), but the first character cannot be a number. This 
value is case-sensitive. 

: The name of the zone. For the ZyWALL USG 300 

and above, use up to 31 characters (a-zA-Z0-9_-). The name 
cannot start with a number. This value is case-sensitive.

The ZyWALL USG 200 and lower models use pre-defined zone 
names like DMZ, LAN1, SSL VPN, WLAN, IPSec VPN, OPT, and 
WAN.

snmp-server rule move rule_number to rule_number

Changes the index number of a service control rule.

no snmp-server rule rule_number

Deletes a service control rule for SNMP service.

show snmp status

Displays SNMP Settings.

Router# configure terminal

Router(config)# snmp-server rule 11 access-group Example zone WAN action accept