ZyXEL Communications 3.1 ユーザーズマニュアル

 Chapter 41 Reports and Reboot

ZyWALL (ZLD) CLI Reference Guide

The following table identifies the values used in some of these commands. Other input values are 
discussed with the corresponding commands.

Use these commands to have the ZyWALL e-mail you system statistics every day. You must use the 

configure terminal

 command to enter the configuration mode before you can use these 

commands.  

show report packet size statistics 

{interface_name} [interval interval]

Displays the specified interface’s packet size distribution statistics. You 
can also specify the packet size interval into which to group the 
statistics.

: 128, 256, or 512 (bytes) 

report packet size statistics clear

Clears the packet size statistics data for all interface.

Packet Size Statistics Commands (continued)

Input Values for Email Daily Report Commands

An e-mail address. You can use up to 80 alphanumeric characters, underscores (_), 
periods (.), or dashes (-), and you must use the @ character.

Email Daily Report Commands

show daily-report status

Displays the e-mail daily report settings.

daily-report

Enters the sub-command mode for configuring daily e-mail 
reports settings.

[no] activate

Turns daily e-mail reports on or off.

draw-usage-graphics

Has the report e-mail include usage graphs. 

smtp-address {ip | hostname}

Sets the SMTP mail server IP address or domain name.

[no] smtp-auth activate

Enables or disables SMTP authentication.

smtp-auth username username password password

Sets the username and password for SMTP authentication.

no smtp-address

Resets the SMTP mail server configuration.

no smtp-auth username

Resets the authentication configuration.

[no] smtp-port <1..65535>

Sets the SMTP authentication port. The no command deletes 
the setting.

mail-subject set subject

Configures the subject of the report e-mails. Spaces are 
allowed.

no mail-subject set

Clears the configured subject for the report e-mails.

[no] mail-subject append system-name

Determines whether the system name will be appended to the 
subject of the report e-mails.

[no] mail-subject append date-time

Determines whether the sending date-time will be appended 
at subject of the report e-mails.

[no] mail-from e_mail

Sets the sender e-mail address of the report e-mails. 

[no] mail-to-1 e_mail

Sets to whom the ZyWALL sends the report e-mails (up to five 
recipients). 

[no] mail-to-2 e_mail

See above.