ZyXEL Communications 3.1 ユーザーズマニュアル

ZyWALL (ZLD) CLI Reference Guide

This chapter describes how to use these two modes.

This is the mode you are in when you first log into the CLI. (Do not confuse ‘user mode’ with types 
of user accounts the ZyWALL uses. See 

 for more information about the 

user types. ‘User’ type accounts can only run ‘exit’ in this mode. However, they may need to log 
into the device in order to be authenticated for ‘user-aware’ policies, for example a firewall rule that 
a particular user is exempt from or a VPN tunnel that only certain people may use.)

Type ‘enable’ to go to ‘privilege mode’. No password is required. All commands can be run from 
here except those marked with an asterisk. Many of these commands are for trouble-shooting 
purposes, for example the htm (hardware test module) and debug commands. Customer support 
may ask you to run some of these commands and send the results if you need assistance 
troubleshooting your device.

For admin logins, all commands are visible in ‘user mode’ but not all can be run there. The following 
table displays which commands can be run in ‘user mode’. All commands can be run in ‘privilege 
mode’.

User (U) and Privilege (P) Mode Commands 

apply

P

Applies a configuration file.

atse

U/P

Displays the seed code

clear

U/P

Clears system or debug logs or DHCP binding.

configure

U/P

Use ‘configure terminal’ to enter configuration mode.

copy

P

Copies configuration files.

debug (*)

U/P

For support personnel only! The device needs to have the debug flag enabled.

delete

P

Deletes configuration files.

details

P

Performs diagnostic commands.

diag

P

Provided for support personnel to collect internal system information. It is not recommended 
that you use these.

diag-info

P

Has the ZyWALL create a new diagnostic file.

dir

P

Lists files in a directory.

disable

U/P

Goes from privilege mode to user mode

enable

U/P

Goes from user mode to privilege mode